The access rule does not affect previously blocked or allowed devices. You don’t need to enter its MAC address in this screen.īlock all new devices from connecting: With this setting, if you add a new device, before it can access your network, you must enter its MAC address for an Ethernet connection and its MAC address for a Wi-Fi connection in the allowed list. 1) Use Default Address 2) Use Computer MAC Address 3) Use This MAC Address (numbers) 2 hardwired computers, 2 hardwired Xbox 360's, 2 Wireless PS3's, 1 laptop, 3 Wireless iPhones - not sure if that makes a difference or not. When this check box is cleared, all devices are allowed to connect, even if a device is in the blocked list.Ĥ. After enabling Access control, choose an Access Rule.Īllow all new devices to connect: With this setting, if you add a new device, it can access your network. You must select this before you can specify an access rule and use the Allow and Block buttons. Wait a few minutes, then power down both your router and your cable modem. How do I specify the Internet connection settings on my Nighthawk router Use Default Address. Click Apply button at the top of the screen to save your changes. If Use Default Address radio button is selected, then change it to Use Computer MAC address or vice versa. Note: If you do not see this option and you already have the latest firmware on your router, please see your user manual to check if this feature is supported by your router. Scroll down to the very bottom, should have a header that reads, 'Router MAC Address'. The router captures and uses the MAC address of the computer that you are now using.
Default login details are: username: admin, password: password. According to the OSI model it is a second-level address. It is assigned by the vendor or manufacturer and saved to the device memory. MAC addresses - hardware addresses that uniquely identifies each node of a network. To configure Access Control or MAC Filtering: MAC address - Media Access Control address.
Note : It is recommended to update your firmware before trying the steps below. Some router features are not available on older firmware versions. If you have an older router with a Smart Wizard interface, please see: Configure Access Control / MAC Filtering using Smart Wizard By using the "Access Control" feature, it is possible to only allow a specified list of wireless devices to connect to the wireless network, and deny access to all or block other wireless devices, even if the users know the correct key or passphrase. By default, NETGEAR wireless routers and access points will connect to any wireless device (computer, smartphone etc.) if the device user enters the correct wireless passphrase or key.